Allied-telesis AT-8100 Series Manual do Utilizador descarregar pdf (Página 188)

Chapter 9: Port Parameters

188

Enabling or Disabling Ports

Disabling ports turns off their receivers and transmitters so that they

cannot forward traffic. You might disable unused ports on the switch to

protect them from unauthorized use, or if there is a problem with a cable or

a network device.

To disable ports, use the SHUTDOWN command in the Port Interface

mode. To enable ports again, use the NO SHUTDOWN command.

This example disables ports 1 to 4:

awplus> enable

awplus# configure terminal

awplus(config)# interface port1.0.1-port1.0.4

awplus(config-if)# shutdown

This example enables ports 17 and 22:

awplus> enable

awplus# configure terminal

awplus(config)# interface port1.0.17,port1.0.22

awplus(config-if)# no shutdown

For reference information, refer to “SHUTDOWN” on page 250 and “NO

SHUTDOWN” on page 224.

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 194 195 196

Sem comentários

Allied-telesis AT-8100 Series Manual do Utilizador Página 188