Allied-telesis AT-9000 Series Manual do Utilizador descarregar pdf (Página 120)

Chapter 7: Basic Switch Management

Restoring the Default Settings to the Switch

To restore the default settings to the switch, delete or rename the active

boot configuration file and then reset the unit. Without an active boot

configuration file, the switch will use the default parameter settings after it

initializes the management software.

Caution

Restoring the default settings requires that you reset the switch. The

unit will not forward network traffic while it initializes the

management software. Some network traffic may be lost.

There are two ways to delete the active boot configuration file. One way is

with the DELETE command in the Privileged Exec mode. Here is the

format of the command:

delete

filename

.cfg

This example deletes the active boot configuration file “Sales_unit.cfg”

and resets the switch:

awplus> enable

awplus# delete Sales_unit.cfg

awplus# reboot

reboot switch? (y/n): y

If you do not know the name of the active boot configuration file, you can

display it with the SHOW BOOT command in the Privileged Exec mode.

Figure 31 is an example of what is displayed:

Figure 31. SHOW BOOT Command

The active boot configuration file is identified in the “Current boot config”

field.

Current software : v1.0.0

Current boot image : v1.0.0

Default boot config: /cfg/boot.cfg

Current boot config: /cfg/switch2.cfg (file exists)

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 147 148

Sem comentários

Allied-telesis AT-9000 Series Manual do Utilizador Página 120