Allied-telesis AT-9000 Series Manual do Utilizador descarregar pdf (Página 222)

Chapter 19: Setting LLDP and LLDP-MED

222

The Modify LLDP Port Configuration page is displayed. See Figure 83.

Figure 83. Modify LLDP Port Configuration Page

4. Change the settings as needed.

The definitions are listed in Step 2. Click on the box next to the field to

select it.

Note

You cannot modify the port ID from this page. To change this field,

go to the previous page (Figure 82, “LLDP Port Config Page” on

page 221) and select Edit next to the port you want to modify.

5. Click Apply.

6. Click SAVE

Assigning Port

Locations

A port location is assigned to a Civic, Coordinate, or ELIN location ID. You

must create these IDs before you assign a port location. For instructions,

see “Setting LLDP Locations” on page 211.

To assign an LLDP port location, do the following:

1. Hover the cursor over the Discovery & Monitoring tab.

The Discovery & Monitoring tab is displayed. See Figure 73 on page

211.

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 257 258

Sem comentários

Allied-telesis AT-9000 Series Manual do Utilizador Página 222