Allied-telesis AT-S41 Manual do Utilizador descarregar pdf (Página 167)

AT-S41 User’s Guide

167

Rebooting a Switch

To reboot a switch, perform the following procedure:

1. Click on the Tools menu tab and select System Reboot from the sub-

menu.

The System Reboot Configuration page will be displayed, as

shown in Figure 51.

Figure 51 System Reboot Configuration

2. Select a Reboot Status of Start from the pull-down menu. The Reboot

Status default setting is Stop.

3. Select a Reboot type from the pull-down menu. There are three

Reboot Type options:

Normal Reset

Resets the switch and saves your configuration changes.

Reset to Factory Default

Resets the switch to its factory default settings. If you select this

option, all of your configuration changes will be erased.

Reset to Factory Default Except IP Address

Resets the switch to its factory default settings except for the IP

address you assigned to the switch.

4. Click the Apply button.

The switch immediately reloads its operating system. This process

will take a few minutes.

Caution

The switch will not forward traffic during the brief period required to

reload its operating software. Some data traffic may be lost.

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 235 236

Sem comentários

Allied-telesis AT-S41 Manual do Utilizador Página 167