Allied-telesis AT-S41 Manual do Utilizador descarregar pdf (Página 175)

AT-S41 User’s Guide

175

Type

The port types. Ports 1-24 are 10/100Base-TX and can operate at

10/100 Mbps. Ports 25-26 are 1000Base-TX and can operate at

10/100/1000 Mbps.

Link Status

The status of the link between the port and the end node

connected to the port. Possible values are:

Up - indicates that a valid link exists between the port and the end

node.

Down - indicates that the port and the end node have not

established a valid link.

Admin. Status

The current operating status of the port.

You might want to disable a port and prevent packets from being

forwarded if a problem occurs with the node or cable connected

to the port. Once the problem has been fixed, you can enable the

port to resume normal operation. You can also disable an unused

port to secure it from unauthorized connections. Possible values

are:

Enabled - The port is able to send and receive Ethernet frames.

This is the default setting for all of the ports on the switch.

Disabled - The port has been manually disabled.

Mode

The current operating settings of the port. Possible values are:

Auto - Indicates that the port is using Auto-Negotiation to set

operating speed and duplex mode. This is the default setting for

all of the ports.

10-HDx - 10 Mbps in half-duplex mode

100-HDx - 100 Mbps in half-duplex mode

10-FDx - 10 Mbps in full-duplex mode

100-FDX - 100 Mbps in full-duplex mode

1000-FDx - 1000 Mbps in full-duplex mode

1000-HDx - 1000 Mbps in half-duplex mode

The 1000 Mbps settings can only be applied on Ports 25-26.

Flow Control

The current flow control setting on the port. The switch uses a

special pause packet to stop the end node from sending frames.

The pause packet notifies the end node to stop transmitting for a

specified period of time.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 235 236

Sem comentários

Allied-telesis AT-S41 Manual do Utilizador Página 175