Allied-telesis AT-S79 Manual do Utilizador descarregar pdf (Página 174)

Chapter 17: Port Mirroring

174 Section II: Using the Web Browser Interface

Configuring Port Mirroring

To set up port mirroring, perform the following procedure:

1. From the Advanced Config menu, select Port Mirroring.

The Port Mirroring page is shown in Figure 47.

Figure 47. Port Mirroring Page

2. In the Mirroring Port section, click Port and from the pull-down menu

select the port where the network analyzer is connected.

3. In the Port Being Mirrored section, click Port and from the pull-down

menu select the port whose ingress and egress traffic you want to

monitor. You can select only one port.

4. Click Apply on the right-hand side of the page.

5. From the Mirroring Status list, select Enable and click Apply.

Port mirroring is immediately enabled on the switch. You can now

connect a data analyzer to the mirroring port to monitor the traffic on

the other port.

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 209 210

Sem comentários

Allied-telesis AT-S79 Manual do Utilizador Página 174