Allied-telesis AT-S97 Manual do Utilizador descarregar pdf (Página 148)

Chapter 8: Configuration File Commands

148

Figure 32. CONFIG SHOW Command with a New Active Master File

If you were to issue the CONFIG SAVE command at this point, the

settings in the “mcf24.cfg” file would be overwritten by the current settings

of the modules. Basically, the settings in the active configuration file would

be replaced by the settings of the master configuration file used during the

last reset, in this case “unit12.cfg,” in addition to any changes that were

make since the last reset or power cycle. And, in some situations, this

might be the goal.

But if the goal is to configure the modules with the settings in “mcf24.cfg,”

you would issue the CONFIG RUN command so that the management

module configures the modules with the settings in the file. If, after issuing

the CONFIG RUN command, you again entered the CONFIG SHOW

command, you would see the information in Figure 33.

Figure 33. CONFIG SHOW Command with a New Current and Active

Master File

Example

config show

Last configuration file ran ............. unit12.cfg

Current set configuration file .......... mcf24.cfg (Exists)

Last configuration file ran ............. mcf24.cfg

Current set configuration file .......... mcf24.cfg (Exists)

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 217 218

Sem comentários

Allied-telesis AT-S97 Manual do Utilizador Página 148