Allied-telesis AT-S97 Manual do Utilizador Página 20

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 218
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 19
Chapter 1: Starting a Command Line Management Session
20
Starting a Local Management Session
Note
Local management sessions do not require an IP configuration on
the AT-MCF2000M Management Module.
To start a local management session on the chassis, perform the following
procedure:
1. Connect the DIN-8 connector on the RS-232 Serial Management
Cable included with the AT-MCF2000M Management Module to the
RS-232 Terminal port on the module, as shown in Figure 2.
Figure 2. Connecting the RS-232 Serial Management Cable to the RS-232
Terminal Port
2. Connect the other end of the cable to an RS-232 port on a terminal or
PC with a terminal emulator program.
3. Configure the terminal or terminal emulation program as follows:
Baud rate: 115200 bps (The RS-232 Terminal port has a baud rate
range of 9600 to 115200 bps. The default is 115200 bps. To adjust
the baud rate, refer to “SYSTEM SET ASYNCHRONOUS” on
page 50.)
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
1203a
AT-MCF2000M
STACK MANAGEMENT
TERMINAL
10/100/1000BASE-T
RS-232
RESET
SD
R
DY BUS Y
MASTER
POWER
BOOT
R
DY
FAULT
1
0
0
0
L
IN
K
AC
T
1
0
/1
0
0
L
IN
K
AC
T
F
D
X
H
D
X
C
O
L
L
IN
K
AC
T
PO
R
T A
CTIV
ITY
AT-MCF2KFAN
NORMAL
FAU LT
STATUS
Vista de página 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 217 218

Comentários a estes Manuais

Sem comentários