Allied-telesis x510 Series Manual do Utilizador descarregar pdf (Página 66)

Chapter 4: Cabling the Networking Ports

Installing SFP

and SFP+

Modules

To install SFP and SFP+ transceivers in slots 27 and 28 of the 28-port

switches and slots 51 and 52 of the 52-port switches, perform the following

procedure:

1. Remove the dust plug from a transceiver slot on the switch. Refer to

Figure 24 on page 66.

Figure 24. Removing the Dust Plug from an SFP+ Slot

2. Remove the transceiver from its shipping container and store the

packaging material in a safe location.

3. If you are installing the transceiver in a top slot, position the

transceiver with the Allied Telesis label facing up. If you are installing

the transceiver in a bottom slot, position the transceiver with the label

facing down.

4. Slide the transceiver into the slot until it clicks into place, as shown in

Figure 25 on page 67.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 89 90

Sem comentários

Allied-telesis x510 Series Manual do Utilizador Página 66