Allied Telesis x3100 Series Guia de Instalação descarregar pdf (Página 5)

4 3BKnown Issues in Release 14.2.1

The heading Level refers to the level of service affected:

• 1: Service Disruption

• 2: Disruption, but Workaround

• 3: Inconvenience

PR Level Title Description

22505 3 Security Officer warning

banner improperly

formatted with SSH Login

When user logs in to system by SSH, then the

Security Officer warning banner may be displayed

with improper formatting. The intent of the message is

still clear, but it looks untidy.

22300 2 XFP can lock up after query On very rare occasions, queries to an XFP on the

SBx31XZ4 card can lock up the IIC control bus for that

port. The result is incorrect (always the same) readings on

subsequent queries. Disabling and re-enabling the port will

clear the condition.

22269 3 DHCP commands do not

check for classifier resource

alarms

All commands that impact classifier resources should

check for classifier resource alarms to warn the user to

check the port. However, DHCP commands do not check

currently.

22214 3 LLDP does not reflect proper

PoE port information

The LLDP messages generated on PoE ports do not

indicate the proper PoE capability.

22138 3 FDB is cleared when a LAG

member port goes link down

The system mistakenly clears the FDB when a LAG

member link is added or removed within the aggregation.

This is unnecessary, and causes flooding briefly until the

addresses are relearned on the LAG.

22097 3 LLDP TTL Value limited to

< 65535

If the Calculated TTL is greater than 65535 seconds, then

the remote node does not display the Remote Interface

Data. This should not be a practical concern, since users

typically have much smaller 'txhold' and 'txtransmit'

values.

21804 2 EPSR provisioning drives

domain state to COMPLETE

Any change to the EPSR timer values at the domain Master

node (e.g. hello, failover, and/or ringflap) causes the

domain state to become COMPLETE, even if a failure is

actually present. If a failure is actually present in the ring

then this could cause a temporary service outage until the

failover timer expires again.

21796 3 setDSCP classifier action

should require setVPriority

action also

The Marvell hardware used on the x3112 requires setting

the queue and/or the user priority (from which one can

derive a queue) when remarking the DSCP value. But the

system does not currently enforce that dependency.

21670 3 Cannot set flowcontrol on

LAG.

The commands to set flowcontrol on a LAG are not

applied to the hardware, even though they are accepted at

the CLI.

1 2 3 4 5 6 7 8 9 10 11 12 13

Comentários a estes Manuais

Sem comentários

Allied Telesis x3100 Series Guia de Instalação Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Comutadores de rede Allied Telesis x3100 Series