Copyright © 2010 Telesis, Inc. All rights reserved Information in this document is subject to change without notice.
6
PR Level Title Description
21618 3 Missing PSU shows actual
temp value.
A PSU that is not present still shows an actual temperature
value of 0. The user should not be confused, because a
value of 0 would be very unusual, and the "DOWN" state
of the PSU is also shown in the same display.
21489 3 Disabled EPSR domain
shows incorrect interface
state
Disabled EPSR domains ignore interface states, and
interface state changes. However, they still display the
values, which may be out-of-date. This is a cosmetic issue,
but might be misleading to a customer. So we must change
it to "-" or "N/A".
21039 2 DHCP Relay fails over LAG If a DHCP client is being serviced directly over aggregated
links, then DHCP Relay will not properly forward the
packets.
21016 3 SD Available capacity size is
never larger than 4G
While SD cards with capacities greater than 4G are
supported, the software currently shows only a maximum
of 4G capacity available.
20942 2 IGMP control packets are
filtered by ACLs/Classifiers
Filtering software on the x3112 filters packets for control
protocols as well (unlike conventional iMAPs). For
example, if DHCP snooping/relay with Auto-IP Filtering is
enabled on an interface, IGMP reports will be filtered by
the x3112 unless the requesting device uses an approved IP
address on the video VLAN. This is different from the
behavior of the traditional 9x00-series iMAPs.
20889 3 LAG interface identifier not
accepted with some
commands
Some commands do not accept the LAG interface (e.g.
lag:0). Instead, you are required to enter a list of all the
member links to identify the target of the operation.
20741 3 Error sending to syslog If a large volume of syslog messages are generated in a
short time (e.g. due to a RESTORE CONFIG or similar
command), then some syslog messages may be lost.
20631 3 Use of telnet client disables
MORE functionality
Show commands (such as 'show config') are displayed at
once (without pause) after some usages of the telnet client.
20560 3 VLAN/HVLAN deletion
clears FDB for other VLANs
When deleting a VLAN (or HVLAN) from an interface the
FDB is cleared for every VLAN (or HVLAN) on that
interface. It should only be cleared for the VLAN (or
HVLAN) being removed. This will cause unnecessary
flooding of packets temporarily, until the MAC address +
VID is learned on that interface again.
20371 2 Card not recognized after
removal during file transfer
If a card is removed during a file transfer, then after
reinsertion it may not be recognized by the controller card.
The workaround for this problem is to remove and reinsert
the card a second time.
18803 3 Swap of activity outputs
duplicate RMON history
buckets
When RMON history is collecting and a swap of activity is
done, then some number of RMON history buckets is
duplicated. There is no ill effect to the data path.
4
(76 páginas)
(35 páginas)
(25 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais