Copyright © 2010 Telesis, Inc. All rights reserved Information in this document is subject to change without notice.
8
PR Level Title Description
21540 3 MAC Thrashing limits are
not visible to the user
Continuously repeated movement of L2 MAC+VID
Addresses to different ports will disable traffic on
the port to protect the system from overload.
However, this action currently does not affect port
operational state nor generate a Management Log.
This has been fixed in 14.2.0. Customer documents
explain the log (PORT005) and status (degraded).
21538 3 GE24/XE4 limited to 8
meters per port
A software limit of 8 traffic descriptors per port
exists on the GE24 and XE4 cards. This limitation
has been corrected in R14.2.0.
21501 3 POE Underload alarm
when cable unplugged
There is an underload alarm for up to 1 minute after
a PD is unplugged from the GE24POE card. This
should be a PD Fault alarm instead. This has been
fixed in 14.2.0. Underload alarm no longer appears
when pulling a PoE interface cable.
21491 3 STP_ORIG mode does not
work with LAG
When STP is set to use STP_ORIG mode with LAG
the LAG interface will not block. This scenario
works properly with RSTP mode. This has been
fixed in release 14.2. When using LAG + STP
Original, you will see the LAG interfaces properly
blocking and forwarding.
21412 2 STP Topology change
does not clear FDB on
LAG
When using STP on a LAG interface, topology
changes do not properly clear the FDB. This could
impact convergence time in this scenario. THis has
been fixed in 14.2.
21260 2 Cannot filter IPv6 packets
based on L4 fields (e.g.
UDP/TCP port #)
All L4 match rules mistakenly assume that they
must match IPv4 packets, and will not match IPv6
packets. This has been fixed in 14.2 IPv6 packets
are now classified when applicable.
21053 2 Links with different
DIRECTION settings are
allowed in the same LAG
The software mistakenly allows links with different
DIRECTION settings (e.g. one CUSTOMER and
one NETWORK) within the same LAG. Until this is
corrected, the user should ensure that the settings are
kept the same. This has been fixed in 14.2 A
direction mis-match will prevent port/interface from
being added to the LAG during CREATE LAG or
ADD LAG command processing.
(76 páginas)
(35 páginas)
(25 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais