Allied Telesis Switch AT-S79 Manual do Utilizador descarregar pdf (Página 193)

AT-S79 Management Software User’s Guide

Section II: Using the Web Browser Interface 193

Enabling and Disabling a Port Trunk

This procedure enables and disables a port trunk. Note the following

before performing this procedure:

 Do not enable a port trunk until after you have configured the trunk on

both switches.

 Do not connect the cables to the ports on the switches until after you

have configured and enabled the trunk on both switches.

Note

If you are disabling a port trunk, be sure to first disconnect all cables

from the ports of the trunk. Leaving the cables connected can create

loops in your network topology because the ports of a disabled port

trunk function as normal network ports, forwarding individual

network traffic.

To enable or disable a port trunk, perform the following procedure:

1. From the Advanced Config menu, select Trunk Config.

The Trunk Configuration page is shown in Figure 54.

2. Click the status of the port trunk and change it to Enable or Disable.

3. Click Apply.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 241 242

Sem comentários

Allied Telesis Switch AT-S79 Manual do Utilizador Página 193