Allied Telesis Switch AT-SBXPWRSYS1 Manual do Utilizador descarregar pdf (Página 179)

SwitchBlade x3112 Installation Guide

179

Warning

Check to see if there are any exposed copper strands coming from

the installed wires. When this installation is done correctly there

should be no exposed copper wire strands extending from the

terminal block. Any exposed wiring can conduct harmful levels of

electricity to persons touching the wires.  E12

6. With a #2 Phillips-head screwdriver, tighten the handle locking screw

to secure the power supply to the chassis. See Figure 137.

Figure 137. Tightening the Handle Locking Screw

7. Before attaching the power wires from the power supply to the circuit

breaker in the wiring closet, check that the circuit breaker is off.

8. Connect the power wires to the circuit breaker.

9. Turn the circuit breaker on.

10. Turn the On/Off switch on the power supply to the On position. See

Figure 138 on page 180.

Handle locking

screw

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 221 222

Sem comentários

Allied Telesis Switch AT-SBXPWRSYS1 Manual do Utilizador Página 179