Allied-telesis AT-2812FX Manual do Utilizador descarregar pdf (Página 72)

Chapter 6: Setting Advanced Properties

4. From the Value list on the Advanced tab, select one of the following:

 None - Disables checksum offloading.

 Rx TCP/IP Checksum - Enables receive TCP, IP, and UDP

checksum offloading.

 Tx TCP/IP Checksum - Enables transmit TCP, IP, and UDP

checksum offloading.

 Tx/Rx TCP/IP Checksum (default) - Enables transmit and receive

TCP, IP, and UDP checksum offloading.

5. Click OK.

6. If prompted to restart your computer, click Yes.

Although it is not necessary to reboot the system for new adapter

properties to take effect, rebooting is recommended to reinitialize all

registers.

7. Verify that the port LED operates as described in “Physical

Description” on page 20.

VLAN ID The VLAN ID specifies the VLAN identifier. It is the number of the VLAN

where the port is an untagged member. You must assign a VLAN ID to a

VLAN. The range is 1 to 4094. The default VLAN has a VLAN ID of 0.

To assign a VLAN ID, do the following:

1. Access the Device Manger for your operating system.

 To access the Windows XP Device Manager, see “Selecting the

Device Manager Window” on page 47.

 To access the Windows Vista Device Manager, see “Selecting the

Device Manager” on page 39.

 To access the Windows 7 Device Manager, see “Selecting the

Device Manager Window” on page 54.

2. Click the Advanced tab.

The Advanced tab is shown in Figure 31 on page 64.

3. Under P

roperty list on the Advanced tab, select VLAN ID.

4. From the V

alue list on the Advanced tab, choose a VLAN ID from 1 to

4094.

Note

The default VLAN has a VLAN ID of 0.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 81 82

Sem comentários

Allied-telesis AT-2812FX Manual do Utilizador Página 72