Allied-telesis AT-S106 Manual do Utilizador descarregar pdf (Página 138)

Chapter 12: Static Multicast MAC Address

138

Setting a Static Multicast Address

This procedure explains how to set the static multicast feature for each

port on the AT-GS950/48 Gigabit Ethernet Smart Switch.

To add a static MAC address to the switch, do the following procedure:

1. From the main menu on the left side of the page, select the Bridge

folder.

2. From the Bridge folder, select Static Multicast.

The Static Multicast Address Table Page is displayed. See Figure 42.

Figure 42. Static Multicast Address Table Page

Before continuing, you must create an 802.1Q VLAN ID(s) or a Port-

Based VLAN Index(es). For information about defining these

parameters, go to:

 “Creating a Tagged VLAN” on page 51 regarding the 802.1Q

VLAN ID parameter.

 “Creating a Port-Based VLAN” on page 56 regarding the Port-

Based VLAN Index parameter.

3. Select either the 802.1Q VLAN ID or Port-Based VLAN Index radio

button and enter the respective VLAN ID (1-4093) or VLAN Index (1 -

65).

Note

An error message will be generated if you enter a VLAN ID or VLAN

Index which has not been defined.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 225 226

Sem comentários

Allied-telesis AT-S106 Manual do Utilizador Página 138