Allied-telesis AT-S47 Manual do Utilizador descarregar pdf (Página 15)

AT-S47 Management Software User’s Guide

Local Management Session

You establish a local management session with an AT-WD1008

multiplexer using the RS-232 port on the AT-WDM02 Management

Module.

Once the session is started, you will see a menu from which you can

make selections to configure and monitor the multiplexer. You can

configure all of the multiplexer’s operating parameters from a local

management session.

Starting a Local

Management

Session

To start a local management session with the multiplexer, perform the

following procedure:

1. Connect a terminal or a personal computer with a terminal emulator

program to the RS-232 port on the AT-WDM02 Management Module,

using the management cable included with the AT-WDM02

Management Module.

2. Configure the terminal or terminal emulator program as follows:

❑ Terminal mode: VT100-compatible / ANSI

❑ Baud rate: 9600

❑ Data bits: 8

❑ Parity: None

❑ Stop bits: 1

❑ Flow control: None

Note

The default settings are for a DEC VT100 or ANSI terminal, or an

equivalent terminal emulation program. Once you have started a

management session, you can adjust the speed and duplex mode of

the RS-232 port. For instructions, refer to Configuring the RS-232

Port on page 35.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 153 154

Sem comentários

Allied-telesis AT-S47 Manual do Utilizador Página 15