Allied-telesis AT-S80 Manual do Utilizador descarregar pdf (Página 195)

AT-S80 Management Software User’s Guide

Section I: Using the Menus Interface 195

Maximum Request.

Sets the maximum number of times that the switch retransmits an EAP

Request packet to the client before it times out the authentication

session. The default value for this parameter is 2 retransmissions. The

range is 1 to 10 retransmissions.

Quiet Period.

Sets the number of seconds that the port remains in the quiet state

following a failed authentication exchange with the client. The default

value is 60 seconds. The range is 0 to 65,535 seconds.

Re-auth Period.

Specifies the time period between periodic reauthentication of the

client. The default value is 3600 seconds. The range is 1 to 65,535

seconds.

Re-auth Status.

Specifies if reauthentication should occur according to the

reauthentication period. The options are Enabled or Disabled.

Current PVID

Displays the current port VLAN identifier or PVID assignment of the

port. You cannot change this value from the Port Based Access

Control Configuration Menu. See Chapter 10, “Virtual LANs” on page

97 for information about assigning a PVID.

Multi-host

Permits you to enable or disable multi-host status.

6. To permit a guest VLAN ID, type G.

The following prompt is displayed:

Enter guest VLAN ID >

a. Type a VLAN ID and then press Enter.

The Port Based Access Control Configuration Menu is updated with

the new guest VLAN ID.

7. To enable 802.1x to support multiple hosts, type O.

The following prompt is displayed:

Enable or disable multi-host status? >

a. Select E to enable multi-host status and D to disable multi-host

status.

The Port Based Access Control Configuration Menu is updated with

the status of the multi-host feature.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 345 346

Sem comentários

Allied-telesis AT-S80 Manual do Utilizador Página 195