Allied-telesis AT-WL2411 Manual do Utilizador descarregar pdf (Página 38)

Configuration Overview

Using a Serial Connection

Although the AT-WL2411 Access Point will work directly out of the box,

you must assign it an IP Address and define other basic parameters

before you can manage it remotely. To perform these initial

configurations, you must use a serial connection and a terminal or a

communications program (such as HyperTerminal). This manual

assumes that you are using a communications program for your initial

configuration and performing all other configurations remotely using

the Web interface.

To perform a basic configuration of the AT-WL2411 using the default

settings, you need the following:

❑ An RS-232 null-modem cable

❑ A terminal or PC with an open serial port

To configure the AT-WL2411, perform the following procedure:

1. Use the RS-232 null-modem cable to connect the serial port on the

access point to a serial port on your PC.

2. Open your communications program and configure the serial

communications parameters on your PC to:

Baud 9600

Data bits 8

Parity no

Stop bit 1

Flow control none

3. Connect the power cable to the access point and to a power source.

The access point does not have an ON/OFF switch, so the unit is ON as

soon as power is applied.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 235 236

Sem comentários

Allied-telesis AT-WL2411 Manual do Utilizador Página 38