Allied-telesis AT-S62 Manual do Utilizador descarregar pdf (Página 162)

100

101

Chapter 8: Port Parameter Commands

162

renegotiation Prompts the port to renegotiate its speed and

duplex mode with the end node. This parameter

only works when the port is using Auto-Negotiation.

The only value is:

auto Renegotiates with the end node speed

and duplex mode.

softreset Resets the port. This parameter does not change any

of a port’s operating parameters.

priority Specifies the port’s priority level. All ingress

untagged packets will be stored in the egress queue

on the egress port that corresponds to the priority

level specified with this parameter. If you include the

OVERRIDEPRIORITY parameter, this will also apply to

all ingress tagged packets. The range is 0 to 7; 0 is

the lowest priority, and 7 is the highest. The default

is 0.

overridepriority Determines if a port should ignore the priority level

in tagged packets and store the packets in the

egress port’s priority queue that corresponds to the

priority level set with the PRIORITY parameter.

Possible values are:

yes, on, true Overrides the priority level in

tagged packets. The values are

equivalent.

no, off, false Does not override the priority in

tagged packets. The values are

equivalent.

Description

This command sets a port’s operating parameters. You can set more

than one parameter at a time. For an explanation of the port parameters,

refer to the AT-S62 Management Software User’s Guide.

Examples

The following command disables ports 1 to 6:

set switch port=1-6 status=disabled

The following command configures port 8 to operate at 10 Mbps, half

duplex:

set switch port=8 speed=10mhalf

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 419 420

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S62 Manual do Utilizador Página 162

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S62