Allied-telesis AT-S70 Manual do Utilizador descarregar pdf (Página 39)

AT-S70 Management Software User’s Guide

Configuring the

Manager IP

Addresses

You can specify up to four network management workstations that will

receive SNMP traps from the system.

To configure the management IP addresses, perform the following

procedure:

1. From the Main Menu, select System Configuration.

The System Configuration Menu, as shown in Figure 5 on page 35, is

displayed.

2. From the System Configuration Menu, select IP Parameters.

The IP Parameters Menu, as shown in Figure 6 on page 37, is

displayed.

3. Adjust the following parameters as necessary:

Manager address(es)

This parameter specifies up to four IP addresses of network

management workstations that will receive SNMP traps from the

chassis. This is optional.

4. Press <Esc> or select the “Return to ...” option at the bottom of the

menu, to save the settings and return to the previous menu.

Configuring

SNMP

Community

Strings

To configure the SNMP community strings, perform the following

procedure:

Note

SNMP access is disabled by default. To enable SNMP access, refer

to “Configuring Management Access” on page 31.

1. From the Main Menu, select System Configuration.

The System Configuration Menu, as shown in Figure 5 on page 35, is

displayed.

2. From the System Configuration Menu, select IP Parameters.

The IP Parameters Menu, as shown in Figure 6 on page 37, is

displayed.

3. Adjust the following parameters as necessary.

Get community string

The default setting for this string is “public.”

Set community string

The default setting for this string is “private.”

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 131 132

Sem comentários

Allied-telesis AT-S70 Manual do Utilizador Página 39