Allied-telesis AT-S97 Manual do Utilizador descarregar pdf (Página 151)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide

151

Note the following guidelines when modifying the commands in this

section:

 Each channel must have its own command line.

 If you delete a command, the corresponding channel’s operating mode

will be Link Test, the default value.

 As previously mentioned, the PORTID parameter must specify just the

channel number. Do not include a chassis ID or slot number. The latter

are defined in the header lines of the Blade Configuration section.

The next subsection in a Blade Configuration, shown in Figure 32,

configures the operating parameters of the ports on the media converter

module, both twisted pair and fiber optic. The port operating parameters

are set with a modified version of the SYSTEM SET PORT command,

where the values in the ID parameter are truncated to the channel number

and port letter. For a description of this command, refer to “SYSTEM SET

PORT” on page 89.

Figure 32. Blade Configuration - Port Operating Parameters

Note the following guidelines when modifying the commands in this

section:

 Each port must have its own command line.

 A port can have more than one command line.

 A command line cannot exceed eighty characters.

 If you delete a port’s configuration command from the file, the port

operates with the default settings.

 The ID parameter specifies just the channel number and port letter.

system set port id=1/a ingress-rate-limit=none egress-rate-limit=none

system set port id=1/b duplex=full ingress-rate-limit=none egress-rate-

limit=none

system set port id=2/a speed=100 duplex=full crossover=mdi

system set port id=2/a ingress-rate-limit=128k egress-rate-limit=none

system set port id=2/b duplex=full ingress-rate-limit=none egress-rate-

limit=none

system set port id=3/a ingress-rate-limit=none egress-rate-limit=none

system set port id=3/b duplex=full ingress-rate-limit=none egress-rate-

limit=none

system set port id=4/a speed=10 duplex=full crossover=mdi

system set port id=4/a ingress-rate-limit=none egress-rate-limit=none

system set port id=4/b duplex=full ingress-rate-limit=none egress-rate-

limit=none

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 253 254

Sem comentários

Allied-telesis AT-S97 Manual do Utilizador Página 151