Allied-telesis AT-S97 Manual do Utilizador descarregar pdf (Página 232)

Chapter 15: Diagnostics Commands

232

Figure 44. DIAGNOSTICS SHOW MODULE Command

The fields in the display are defined here:

 Name - The name of the module. Refer to “SYSTEM SET MODULE”

on page 86 for instructions on assigning a name to a module.

 Model - The model name.

 MAC - The module’s MAC address.

 SN - The module’s serial number.

 HW Rev. - The module’s hardware revision level.

 Software Version - The version number of the AT-S85 or AT-S97

Management Software.

 Voltages - Input voltages on the module.

 Temperature - The current temperature of the module.

 Temperature Threshold - The temperature threshold of a module. The

management module logs an event in the event log if the threshold is

exceeded, to warn of possible excessive temperature in the wiring

closet or chassis. Refer to “SYSTEM SET MODULE” on page 86 for

instructions on setting a module’s temperature threshold.

Eeprom Information

Name .......................

Model ...................... AT-MCF2012LC

MAC ........................ 00:15:77:70:7A:22

SN ......................... 14

HW Rev ..................... 1

CPU Software Information:

Software Version ........... v2.0.0

CPU Information:

Name .......................

Module Type ................ AT-MCF2012LC

Module Status .............. Active

Module Present ............. Present

1.2V ....................... Good = 1.198

1.8V ....................... Good = 1.804V

2.5V ....................... Good = 2.509

3.3V ....................... Good = 3.302V

12.0V ...................... Good = 12.6224

Temperature ................ 38.15V

Temperature Threshold ...... 60 C

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 253 254

Sem comentários

Allied-telesis AT-S97 Manual do Utilizador Página 232