
Chapter 7: Powering On the Chassis
182
4. Using a #1 Phillips-head screwdriver, remove the two screws that
secure the plastic cover over the positive and negative terminals and
remove the plastic cover from the power supply, as shown in
Figure 137. You may need to lift the locking handle slightly to access
the bottom screw.
Figure 137. Removing the Plastic Cover
The plastic cover is not used with the right angle terminals.
5. Use a #3 Phillips-head screwdriver to remove the two screws from the
positive and negative terminals, as shown in Figure 138 on page 183.
Comentários a estes Manuais