Allied Telesis Rapier 16Fi-FX Guia de Instalação descarregar pdf (Página 14)

14 System Enhancements Release Note

Software Version 2.9.1

C613-10486-00 REV C

Increased Module Support by Show Debug Active

This Software Version increases the number of modules supported by the show

debug active and disable debug active commands. See “Supported Modules”

on page 15 for the list of newly supported modules.

To display the debugging options that are active on the router or switch for the

supported modules, use the command:

show debug active={all|module}

To disable debugging on the supported modules, use the command:

disable debug active={all|module}

Command Changes

The following table summarises the modified commands:

Command Reference Updates

This section describes each new command and the changed portions of

modified commands and output screens. For modified commands and output,

the new parameters, options, and fields are shown in bold.

activate findme

Syntax ACTivate FINdme [TIme=time]

Description This command enables you to physically locate a specific switch from others

that are co-located. This command causes the switch’s LEDs to flash green and

amber at a rate of 0.5 Hzs. Normal LED behaviour is restored automatically

after either the default time, or a specified time, has elapsed, or manually by

using the deactivate findme command.

The time parameter specifies the time period until normal LED behaviour is

restored. The duration can be set between 10 and 3600 seconds. The default

is 60.

Examples To activate the “find me” feature for the default amount of time, use the

command:

act fin

To activate the “find me” feature for 2 minutes (120 seconds), use the

command:

act fin ti=120

Command Change

disable debug active New module options for active parameter

show debug active New module options for active parameter

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 282 283

Sem comentários

Allied Telesis Rapier 16Fi-FX Guia de Instalação Página 14