Allied Telesis AT-8000S Guia do Utilizador descarregar pdf (Página 112)

Configuring Spanning Tree

Configuring Classic Spanning Tree

Page 113

Defining STP Interfaces

Network administrators can assign STP settings to a specific interface (port or trunk) using the STP Interface

Configuration Page. The Global trunks section displays the STP information for Link Aggregated Groups.

To assign STP settings to an interface (port or trunk):

1. Click Layer 2 > Spanning Tree. The Spanning Tree Page opens.

2. Click Configure. The STP Interface Configuration Page opens:

Figure 82: STP Interface Configuration Page

The STP Interface Configuration Page contains the following sections:

• STP Port Parameters table

• Global System Trunk table

The parameters listed in both tables are identical.

The STP Interface Configuration Page contains the following fields:

• Select the interfaces displayed in the table.

– Ports of Unit — Specifies the port and stacking member for which the STP settings are displayed.

– Trunk — Specifies the trunk for which the STP settings are displayed.

• Port/Trunks — Indicates the port or trunk number.

• STP — Indicates if STP is enabled on the port. The possible field values are:

– Enabled — Indicates that STP is enabled on the port.

– Disabled — Indicates that STP is disabled on the port.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 203 204

Sem comentários

Allied Telesis AT-8000S Guia do Utilizador Página 112