Allied-telesis AT-S101 Manual do Utilizador descarregar pdf (Página 105)

AT-S101 Management Software User’s Guide

105

Modifying an SNMP Community

Use the following procedure to modify the access level or a community

name of an SNMP community in the Community Table.

1. From the menu on the left side of the page, select the SNMP folder.

The SNMP folder expands.

2. From the SNMP folder, select Community Table.

The Community Table Page is shown in Figure 31 on page 104.

3. To change the access level of an SNMP community, select the pull-

down menu under the Access column in the Community table for the

community you want to modify.

4. Select Read-Only access or Read-Write access.

5. To change the community name, type over an existing community

name. Then click Apply.

Note

You cannot change the index number of an SNMP community.

6. From the menu on the left side of the page, select Save Configuration

to Flash to save your changes.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 237 238

Sem comentários

Allied-telesis AT-S101 Manual do Utilizador Página 105