Allied-telesis AT-S101 Manual do Utilizador descarregar pdf (Página 22)

Chapter 2: Basic Switch Parameters

Configuring an IP Address, Subnet Mask and Gateway Address

This procedure explains how to change the IP address, subnet mask, and

gateway address to the switch. Before performing the procedure, note the

following:

 A gateway address is only required if you want to remotely manage

the device from a management station that is separated from the

switch by a router.

 To configure the switch to automatically obtain its IP configuration from

a DHCP server on your network, go to “Enabling and Disabling the

DHCP Client” on page 27.

To change the switch’s IP configuration, perform the following procedure:

1. From the menu on the left side of the page, click the System folder.

The System folder expands.

2. From the System folder, select IP Setup.

The IP Setup Page is shown in Figure 5.

Figure 5. IP Setup Page

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 237 238

Sem comentários

Allied-telesis AT-S101 Manual do Utilizador Página 22