Allied-telesis AT-S101 Manual do Utilizador descarregar pdf (Página 131)

AT-S101 Management Software User’s Guide

131

Modifying a Static Multicast Address

To modify the port assignment of a multicast MAC address in the MAC

address table, perform the following procedure:

1. From the menu on the left side of the page, select the Bridge folder.

The Bridge folder expands to display several folders including the

Trunk Config. folder.

2. From the Trunk Config. folder, select Static Multicast.

The Static Multicast Address Table Page is displayed. See Figure 39

on page 129.

3. Select modify next to the static MAC address that you want to modify.

The Modify Static Multicast Address Page is displayed. See Figure 40.

Figure 40. Modify Static Multicast Address Page

4. In the Group Member row, select the ports that you want to include in

the group MAC address.

Selected ports are indicated with a check mark. Each port has a

maximum limit of 32 static multicast addresses.

5. Then click Apply to apply your changes.

Note

To restore the original group member ports, click Restore.

6. From the menu on the left side of the page, select Save Configuration

to Flash to save your changes.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 237 238

Sem comentários

Allied-telesis AT-S101 Manual do Utilizador Página 131