Allied-telesis AT-S95 CLI Manual do Utilizador descarregar pdf (Página 179)

100

101

LLDP Commands

Page 179

Example

The following example displays the Link Layer Discovery Protocol (LLDP) configuration:

The following table describes the significant fields shown in the example:

show lldp med configuration

The show lldp med configuration Privileged EXEC mode command displays the LLDP MED configuration.

Syntax

show lldp med configuration [ethernet interface]

console# show lldp configuration

State: Enabled

Timer: 30 Seconds

Hold multiplier: 4

Reinit delay: 2 Seconds

Tx delay: 2 Seconds

Port State Optional TLVs Address

---- ----- ------------- -------

1/e1 RX, TX PD, SN, SD, SC 172.16.1.1

1/e2 TX PD, SN 172.16.1.1

1/e3 Disabled

Field Description

Timer Specifies how often the software sends LLDP updates.

Hold multiplier Specifies the amount of time the receiving device should hold an LLDP packet

before discarding it.

Reinit timer Specifies the minimum time an LLDP port waits before reinitializing LLDP

transmission.

Tx delay Specifies the delay between successive LLDP frame transmissions initiated by

value/status changes in the LLDP local systems MIB.

Port The port number.

State The port LLDP state.

Optional TLVs Optional TLVs that are advertised. Possible values are:

• PD – Port description

• SN – System name

• SD – System description

• SC – System capabilities

Address The management address that is advertised.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 391 392

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S95 CLI Manual do Utilizador Página 179

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S95 CLI