Allied-telesis AT-S95 CLI Manual do Utilizador descarregar pdf (Página 190)

Page 190

Allied Telesis

AT-S95 Management Software CLI User’s Guide

User Guidelines

Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is defined on the

appropriate interface.

The system supports up to 128 management access rules.

Example

The following example permits all ports in the mlist Access List.

deny (Management)

The deny Management Access-List Configuration mode command defines a deny rule.

Syntax

deny [ethernet interface-number | vlan vlan-id | port-channel port-channel-number] [service service]

deny ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-id | port-channel

port-channel-number] [service service]

Parameters

•

interface-number — A valid Ethernet port number.

• vlan-id — A valid VLAN number.

• port-channel-number — A valid port-channel number.

• ip-address — A valid source IP address.

• mask — A valid network mask of the source IP address.

• mask prefix-length — Specifies the number of bits that comprise the source IP address prefix. The prefix

length must be preceded by a forward slash (/). (Range: 0 - 32)

• service — Service type. Possible values: telnet, ssh, http, https and snmp.

Default Configuration

This command has no default configuration.

Command Mode

Management Access-list Configuration mode

User Guidelines

Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is defined on the

appropriate interface.

The system supports up to 128 management access rules.

console(config)#

management access-list

mlist

console(config-macl)#

permit

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 391 392

Sem comentários

Allied-telesis AT-S95 CLI Manual do Utilizador Página 190