Allied-telesis AT-S95 CLI Manual do Utilizador descarregar pdf (Página 202)

100

101

Page 202

Allied Telesis

AT-S95 Management Software CLI User’s Guide

Chapter 22.Power over Ethernet Commands

power inline

The port inline Interface Configuration (Ethernet) mode command configures the administrative mode of inline

power on an interface.

Syntax

power inline {auto | never}

Parameters

•

auto — Enables the device discovery protocol and, if found, supplies power to the device.

• never — Disables the device discovery protocol and stops supplying power to the device.

Default Configuration

The device discovery protocol is enabled.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

There are no user guidelines for this command.

Example

The following example enables powered device discovery protocol on port 1/e16, so that power will be supplied to

a discovered device.

power inline powered-device

The power inline powered-device Interface Configuration (Ethernet) mode command adds a comment or

description of the powered device type to enable the user to remember what is attached to the interface. Use the

no form of this command to remove the description.

Syntax

power inline powered-device pd-type

no power inline powered-device

Parameters

•

pd-type — Specifies the type of powered device attached to the interface. (Range: 1 - 24 characters)

console(config)#

interface ethernet

1/e16

console(config-if)#

power inline auto

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 391 392

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S95 CLI Manual do Utilizador Página 202

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S95 CLI