Allied-telesis SwitchBlade x8112 Manual do Utilizador descarregar pdf (Página 106)

Chapter 4: Installing the Power Supplies

106

7. Lower the locking handle of the power supply module to secure the

module in the slot, as shown in Figure 61.

Figure 61. Locking the Handle on the AT-SBxPWRSYS1 DC System

Power Supply

Note

Do not tighten the handle locking screw yet. You may need to

slightly lift the handle to move the plastic guard panel when you wire

the positive and negative wires in “Powering On the AT-

SBxPWRSYS1 DC System Power Supply” on page 151.

8. To install a second AT-SBxPWRSYS1 DC System Power Supply,

repeat this procedure.

9. After installing the power supplies, go to Chapter 5, “Installing the AT-

SBx81CFC400 Control Card and Ethernet Line Cards” on page 107.

Note

Retain the five wire ring lugs that come with the power supply. You

use them to wire the power supply in Chapter 7, “Powering On the

Chassis” on page 141.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 239 240

Sem comentários

Allied-telesis SwitchBlade x8112 Manual do Utilizador Página 106