Allied-telesis SwitchBlade x8112 Manual do Utilizador descarregar pdf (Página 170)

Chapter 7: Powering On the Chassis

170

Figure 124. Tightening the Handle Locking Screw

9. Before attaching the power wires from the power supply to the circuit

breaker in the wiring closet, check that the circuit breaker is off.

10. Connect the power wires to the circuit breaker.

11. Turn the circuit breaker on.

12. Turn the On/Off switch on the power supply to the On position. See

Figure 111 on page 158.

13. Do one of the following:

 If the chassis has two AT-SBxPWRSYS1 DC Power Supplies,

repeat this procedure to power on the second power supply.

 Otherwise, go to “Monitoring the Initialization Process” on

page 175.

Handle locking

screw

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 239 240

Sem comentários

Allied-telesis SwitchBlade x8112 Manual do Utilizador Página 170