Allied-telesis x510 Series Manual do Utilizador descarregar pdf (Página 40)

Chapter 1: Overview

The switch displays the letter “F” for fault on the ID LED if it encounters

one of the following problems:

 A cooling fan has failed.

 One of the power supplies has failed.

 The internal temperature of the switch has exceeded the normal

operating range and the switch may shut down.

Note

You can use the SHOW SYSTEM ENVIRONMENT command in the

command line interface to identify the source of the problem.

The states of the LED when the switch is operating in the low power mode

are shown in Figure 12.

Figure 12. Switch ID LEDs in the Low Power Mode

The switch is the master switch of a VCStack.

The switch is operating as a stand-alone unit.

The switch is a member switch of a VCStack.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 121 122

Sem comentários

Allied-telesis x510 Series Manual do Utilizador Página 40