Allied-telesis x510 Series Manual do Utilizador descarregar pdf (Página 78)

Chapter 5: Verifying the Status of VCStack

9. Check the ID LED and do one of the following:

 If the ID LED is displaying the number 1, 2, 3, or 4, VCStack is now

enabled on the switch. Power off the switch by disconnecting the

power cord and repeat the procedures in this chapter on the next

switch. If there are no further switches to test, go to Chapter 6,

“Cabling the Stacking Ports” on page 79.

 If the ID LED is still displaying “0,” repeat this procedure. If the

procedure was not successful, it might be because you did not

issue the WRITE command in step 5 to save your change.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 121 122

Sem comentários

Allied-telesis x510 Series Manual do Utilizador Página 78