Allied Telesis Patch 86261-04 Manual do Utilizador descarregar pdf (Página 10)

10 Patch Release Note

Patch 86261-09 for Software Release 2.6.1

C613-10388-00 REV J

In rapid STP mode, if a port was disabled, then the command set stp default

was executed, the port could not be re-enabled. This issue has been

resolved.

When a classifier-based hardware filter was added, certain classifier

numbers, such as 1023, 1024, 2047, and 2048, would cause the switch to

reboot. This issue has been resolved.

In rapid STP mode, the set stp default command would not reset the STP

default values for Max Age, Hello Time, and Forward Delay. This issue has

been resolved.

OSPF would reject IP packets that, after being reassembled, were larger than

the standard buffer size of 1800 bytes. This has been resolved by enabling

OSPF to process IP fragments whose reassembled size is up to 64 K bytes

long.

The GUI was not recognising an AT-G8SX-01 GBIC. This issue has been

resolved.

When an interface that was a designated router (DR) went to the down

state, the Network LSA was not being flushed from the routing domain.

For compliance with RFC 2328 12.4 , the Network LSA will now be flushed

out.

Previously when 10/100 copper ports were disabled, the link state was

automatically taken down. Users are now able to select whether ports are

disabled or enabled. The option is applied using the command:

disable switch port={port-list|all} [flow=pause]

[link={enable/disable}]

When link is set to disable, the port is electrically disabled (the link is taken

down). When the link is set to enable the port is disabled, but the link

remains up.

When a router uses OSPF over PPP and one of its PPP links was lost, the LS

updates were not alerting the router’s neighbours (via links on its other

interfaces) of the PPP outage. This issue has been resolved.

PCR: 40131 Module: SWMX Level: 2

PCR: 40134 Module: SWI Level: ?

PCR: 40132 Module: STP Level: 2

PCR: 40137 Module: OSPF Level: 3

PCR: 40138 Module: SWCX Level: 2

PCR: 40142 Module: OSPF Level: 2

PCR: 40143 Module: SWI Level: 2

PCR: 40150 Module: PPP Level: 2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Sem comentários

Allied Telesis Patch 86261-04 Manual do Utilizador Página 10