Allied Telesis Patch 86261-04 Manual do Utilizador descarregar pdf (Página 18)

18 Patch Release Note

Patch 86261-09 for Software Release 2.6.1

C613-10388-00 REV J

On AT-8800 series switches, a warning log message was generated for the

fan’s status when there was more than a 20% variation in fan speed between

“Actual” and “Expected”. This has been changed so the log message is only

generated when the fan stops.

When there were multiple routes to the same destination, the wrong port

number occasionally appeared in a Layer 3 switch hardware table entry.

This could lead to incorrect traffic flow. This issue has been resolved.

Features in 86261-04

Patch file details are listed in Table 4:

Patch 86261-04 includes all issues resolved and enhancements released in

previous patches for Software Release 2.6.1, and the following enhancements:

When RIP demand mode was enabled, and one interface changed to a

reachable state, the triggered Request packet was not sent from that

interface, and triggered Response packets were not sent from all other RIP

interfaces. This resulted in slow convergence of routing tables across the

network. This issue has been resolved.

Support has been added for the AT-AR021 (S) BRI-S/T PIC (Port Interface

Card) with basic rate ISDN.

RIP did not send the correct next hop address if the route originated from a

different subnet to that of the egress interface. This issue has been resolved.

If an IPv6 filter that blocked traffic on a VLAN interface was removed, the

traffic was still blocked. This issue has been resolved.

PCR: 40070 Module: CORE Level: 3

PCR: 40091 Module: IPG Level: 2

Table 4: Patch file details for Patch 86261-04.

Base Software Release File

86-261.rez

Patch Release Date

19-Nov-2003

Compressed Patch File Name

86261-04.paz

Compressed Patch File Size

261628 bytes

PCR: 03910 Module: IPG Level: 3

PCR: 03927 Module: BRI

PCR: 03967 Module: IPG Level: 2

PCR: 03970 Module: IPV6 Level: 3

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Sem comentários

Allied Telesis Patch 86261-04 Manual do Utilizador Página 18