Allied Telesis Patch 86261-04 Manual do Utilizador descarregar pdf (Página 15)

Patch 86261-09 For Rapier and AT-8800 Series Switches 15

Patch 86261-09 for Software Release 2.6.1

C613-10388-00 REV J

When the DHCP server rejected a DHCPRequest message, the requested IP

address was not logged correctly. This issue has been resolved.

The command:

reset user[=login-name] [counters[={all|global|user}]]

did not permit the valid combination of specifying a USER login name

without the optional COUNTER parameter. This issue has been resolved.

PCR 31128 introduced an issue that occasionally caused a fatal error with IP

flows. This issue has been resolved.

A rule that was defined to change the UDP port did not succeed when

standard NAT was configured. This issue has been resolved.

Executing the SHOW DEBUG command caused a fatal error if the

temporary log had been destroyed with the DESTROY LOG

OUTPUT=TEMPORARY command. This issue has been resolved.

When an interface-based enhanced NAT was defined in a firewall policy,

and a reverse NAT rule was defined to redirect traffic to a proxy server, the

reverse NAT did not work correctly. The proxy server did not receive any

traffic from the device. This issue has been resolved.

When the device operated in NTP Client mode, the SHOW TIME command

sometimes displayed the incorrect time. This issue has been resolved.

The ADD OSPF INTERFACE=virt0-0 command was incorrectly written to

the configuration file. The interface virt0-0 can not be added as an OSPF

interface. The correct command, ADD OSPF INTERFACE=virt0, is now

written to the configuration file by the CREATE CONFIG command.

The device sometimes rebooted when OSPF on demand was enabled for

PPP. This issue has been resolved.

When a port’s ingress limit was set to less than 1000 with the

INGRESSLIMIT parameter in the SET SWITCH PORT command, sending

packets to a tagged port caused FCS errors on transmission. This issue has

been resolved.

PCR: 31259 Module: DHCP Level: 2

PCR: 31264 Module: USER Level: 3

PCR: 31268 Module: IPG Level: 2

PCR: 40003 Module: FIREWALL Level: 2

PCR: 40006 Module: LOG Level: 2

PCR: 40007 Module: FIREWALL Level: 2

PCR: 40008 Module: NTP Level: 3

PCR: 40011 Module: OSPF Level: 3

PCR: 40012 Module: IPG, OSPF Level: 2

PCR: 40020 Module: SW56 Level: 3

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Sem comentários

Allied Telesis Patch 86261-04 Manual do Utilizador Página 15