Allied Telesis Patch 86261-04 Manual do Utilizador descarregar pdf (Página 6)

6 Patch Release Note

Patch 86261-09 for Software Release 2.6.1

C613-10388-00 REV J

The control parameter in the set portauth port supplicant command was

incorrectly reflected in the dynamic configuration if that command was

executed when port authentication was disabled. This issue has been

resolved.

DVMRP now interoperates with all Cisco IOS versions.

If a mirror port was configured using the set swi port mirror command, and

then the enable switch mirror command was entered, the switch would

issue a warning that no mirror port had been set. This issue has been

resolved.

Executing the reset switch command was causing the Rapier 48 switch to

lockup. This issue has been resolved.

When using PPP multilink, many frames were being incorrectly marked as

lost. Depending on the number of PPP links configured, this resulted in

degraded performance and an occasional a loss of connectivity. This issue

has been resolved.

The switch has been enhanced to enable a text message to be displayed on

the user’s console immediately after logging into the device. This message

must be contained within an ASCII text file called login.txt and reside in

flash memory.

On AT-8800 series switches, a warning log message was generated for the

fan’s status when there was more than a 20% variation in fan speed between

“Actual” and “Expected”. This has been changed so the log message is only

generated when the fan stops.

Routing tables were not being updated correctly when better BGP routes

were learnt. This issue has been resolved.

The calling-station ID was not being sent to Radius when authenticating a

PPPoE connection. This issue has been resolved.

When port authentication was enabled, the command enable switch port

had no effect, when entered from the GIU, even when port authentication

affecting parameters were set to default. This issue has been resolved.

PCR: 40058 Module: PORTAUTH Level: 3

PCR: 40059 Module: DVMRP Level: 2

PCR: 40062 Module: SWI Level: 3

PCR: 40064 Module: SW56 Level: 2

PCR: 40067 Module: MNIX Level: 2

PCR: 40068 Module: SCR, TTY, USER Enhancement

PCR: 40070 Module: CORE Level: 3

PCR: 40071 Module: IPG Level: 2

PCR: 40076 Module: USER, PPP Level: 2

PCR: 40079 Module: SWI Level: 3

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Comentários a estes Manuais

Sem comentários

Allied Telesis Patch 86261-04 Manual do Utilizador Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Comutadores de rede Allied Telesis Patch 86261-04