Allied-telesis AT-8202 Manual do Utilizador descarregar pdf (Página 20)

Configuring Point-to-Point (PTOP)

1-12

Configuring Point-to-Point (PTOP)

PTOP bridging enables setup between two or more parties to share a

virtual channel connection (VCC) using either a permanent virtual

connection (PVC) or a switched virtual connection (SVC). This feature

supports up to 16 PTOP connections. Only one VLAN and one VCI at a

time can participate in a PTOP conﬁguration.

To conﬁgure PTOP parameters for an ATM service, you need to:

❑ Set the PTOP instance ID.

❑ Set the VCI value.

❑ Set the port service for binding an ATM port.

A VLAN with a valid IP address must exist prior to conﬁguring PTOP.

To configure PTOP:

Note

Values shown are for example purposes only; replace with values that

apply to your own configuration.

1. Verify the existence of the VLAN you plan to configure by using

the

VLAN/SHOW/VLAN command.

Note

If the VLAN does not exist, create it using the VLAN/CONFIG/VLAN #

command.

2. Create the PTOP services using the

ATM/CONFIG/CREATE/

PTOP <PTOP Instance ID> command.

/VLAN/SHOW >VLAN

Virtual LAN Information:

VLAN VLAN IP Network Admin Operation Port

ID Description Address Status Status Membership

==== =============== ========== ======= ======= ==========

1 Default VLAN(#1 1.1.1.1 ENABLE ACTIVE 1-16

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

Sem comentários

Allied-telesis AT-8202 Manual do Utilizador Página 20