Allied-telesis AT-8202 Manual do Utilizador descarregar pdf (Página 47)

AT-8202 ATM Uplink User’s Guide

2-19

ATM/CONFIG/MODIFY Commands

Syntax and (alias)

ATM/CONFIG/MODIFY/CIP (mcip)

ATM/CONFIG/MODIFY/LEC (mlec)

ATM/CONFIG/MODIFY/PORT (map)

ATM/CONFIG/MODIFY/PTOP (mptop)

ATM/CONFIG/MODIFY/TRUNK (mtrunk)

Description

The

ATM/CONFIG/MODIFY commands allow you to modify services

that you have created (via the

ATM/CONFIG/CREATE command).

See the command examples for a brief description of these services.

ATM/CONFIG/MODIFY/CIP <CIP Index> Example

This command allows you to modify a CIP entity (a member of an LIS)

using <CIP Index>. If that index does not exist, the screen displays

the error message, No Such CIP. This command displays the same

screen as the

ATM/CONFIG/CREATE/CIP <CIP Index> command.

You can modify some of the parameters of the CIP entity while the

CIP is in service, and without affecting the open connections

associated with that CIP. However, you cannot modify certain

parameters such as the IP address, subnet mask, etc. without taking

the CIP entity out of service. Under these conditions, use

ATM/

DELETE/CIP followed by ATM/CREATE/CIP in place of ATM/

MODIFY/CIP.

ATM/CONFIG/MODIFY/LEC <LEC Number> Example

This command allows you to modify a LEC as speciﬁed by <LEC

Number>. If that index does not already exist, the screen displays the

error message, LEC <LEC Number> does not exist. This

command displays the same screen as

ATM/CONFIG/CREATE/LEC

<LEC Number>.

ATM/CONFIG/MODIFY/PORT Example

The ATM port is conﬁgured with certain default parameters. This

command changes some of the default settings to suit a speciﬁc

network conﬁguration. A sample display of

ATM/CONFIG/MODIFY/

PORT is shown below, and parameters are described in Table 2-6.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 79 80

Sem comentários

Allied-telesis AT-8202 Manual do Utilizador Página 47