Allied-telesis AT-S97 Manual do Utilizador descarregar pdf (Página 165)

AT-S85 and AT-S97 Management Software User’s Guide

165

After designating an active master configuration file, do one of the

following:

 To configure the modules in the chassis or stack according to the

settings in the newly designated active master configuration file, issue

the CONFIG RUN command. For instructions, refer to “CONFIG RUN”

on page 160. Do not issue the CONFIG SAVE command.

 To overwrite the settings in the active master configuration file with the

current settings of the modules, issue the CONFIG SAVE command.

For instructions, refer to “CONFIG SAVE” on page 161.

Note the following before using this command:

 To view the name of an active master configuration file, see “CONFIG

SHOW” on page 166.

 The designated file must already exist. To view the configuration files

in the management module’s file system, see “FILE SHOW” on

page 191. Configuration files have a “.cfg” extension. To create a new

configuration file, refer to “CONFIG SAVE” on page 161.

For further information, refer to “Specifying the Active Master

Configuration File” on page 149.

Examples

This command designates the file “mc22.cfg” in the file system on the

management module as the active master configuration file. The chassis

has the ID number 0:

config set filesystem=system://0/m/mc22.cfg

This command designates the file “mcf2000 b12.cfg” as the active master

configuration file for the chassis with the ID number 0:

config set filesystem=system://0/m/"mcf2000 b12.cfg"

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 247 248

Sem comentários

Allied-telesis AT-S97 Manual do Utilizador Página 165