Allied-telesis AT-S97 Manual do Utilizador descarregar pdf (Página 30)

Chapter 1: Starting a Management Session

What to Configure First

This section has a few suggestions on what to configure during your first

management session. The initial management session must be a local

session. For instructions on how to start a local management session,

refer to “Starting a Local Management Session” on page 18.

Note

Although the management module comes with the default IP

address of 10.0.0.1 and subnet mask of 255.255.252.0, the initial

configuration must be a local session because the module’s Telnet

and SSH servers are initially disabled.

Displaying the

Chassis Modules

After logging on, enter this command:

system show cluster

The command is used to display and verify the management module and

the media converter modules in a chassis. An example is shown in Figure

Figure 5. Displaying the Chassis Modules

Chassis Chassis Chassis MAC Master

ID Name Type Address Chassis

--------------------------------------------------------------------------------------

0 AT-MCF2000 11:22:33:44:55:55 Yes

AT-MCF2000

Slot ID Module Name Module Type Cfg Overwrite Software Version

------------------------------------------------------------------------------

M AT-MCF2000M v3.0.0

1 AT-MCF2012LC Disable v3.0.0

2 AT-MCF2012LC/1 Disable v3.0.0

Chassis information

Management and media converter module information

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 247 248

Sem comentários

Allied-telesis AT-S97 Manual do Utilizador Página 30