Allied-telesis AT-S97 Manual do Utilizador descarregar pdf (Página 94)

Chapter 5: Port and Module Commands

module. This setting is not supported on the

twisted pair ports on the AT-MCF2012LC and

AT-MCF2012LC/1 Media Converter Modules.

duplex Sets the duplex mode of a port. The available settings are:

full Sets the duplex mode of the port to full-duplex.

This is the default setting for a fiber optic port

that does not support Auto-Negotiation.

half Sets the duplex mode of the port to half-duplex.

crossover Sets the wiring configuration of a twisted pair port. Auto-

Negotiation must be disabled on the port to set this

parameter. The available settings are:

mdi Sets the wiring configuration to MDI.

mdix Sets the wiring configuration to MDI-X.

ingress-rate-limit

Defines the maximum number of bits per second a port will

accept from the network device connected to it. The ranges

are 62 to 256000 kbps for the AT-MCF2012LC and

AT-MCF2012LC/1 Media Converter Modules, and 59 to

1000000 kbps for the AT-MCF2032SP Media Converter

Module.

egress-rate-limit

Defines the maximum number of bits per second a port will

transmit to the network device connected to it. The ranges

are 62 to 256000 kbps for the AT-MCF2012LC and

AT-MCF2012LC/1 Media Converter Modules, and 59 to

1000000 kbps for the AT-MCF2032SP Media Converter

Module.

Privilege Levels

Administrator and read-write.

Description

This command is used to configure the following parameter settings on a

twisted pair port or a fiber optic port in a channel on a media converter

module:

 Port status

 Auto-Negotiation

 Speed and duplex mode

 MDI/MDI-X wiring configuration

 Ingress and egress filtering

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 247 248

Sem comentários

Allied-telesis AT-S97 Manual do Utilizador Página 94