Allied-telesis AT-S97 Manual do Utilizador descarregar pdf (Página 37)

AT-S85 and AT-S97 Management Software User’s Guide

Replacing a Media Converter Module

To replace a module:

1. Install the new module in the chassis. For instructions, refer to the

AT-MCF2300 Multi-channel Media Converter Series Installation Guide.

2. Wait one minute for the module to initialize its management software.

3. Start a local or remote management session on the chassis or stack.

For instructions, refer to “Starting a Local Management Session” on

page 18 or “Starting a Remote Telnet or Secure Shell Management

Session” on page 20.

4. Enter this command:

system show cluster

5. Examine in the display the configuration overwrite setting of the media

converter module you just installed.

Figure 7. Determining the Configuration Overwrite Setting of a Media

Converter Module

 If the overwrite setting is enabled, the module seeks its

configuration from the management module and the master

configuration file. If the media converter module that previously

occupied the slot was the same model, than the new module is

assigned the very same configuration settings, automatically. If the

slot had not been used before or if the previous module was a

different model, the newly installed module uses its own auxiliary

configuration file in flash memory to set its parameters, or if it has

never been used before, it uses the default values.

Chassis Chassis Chassis MAC Master

ID Name Type Address Chassis

--------------------------------------------------------------------------------------

0 AT-MCF2000 11:22:33:44:55:55 Yes

AT-MCF2000

Slot ID Module Name Module Type Cfg Overwrite Software Version

------------------------------------------------------------------------------

M AT-MCF2000M v3.0.0

1 AT-MCF2012LC Disable v3.0.0

2 AT-MCF2012LC/1 Disable v3.0.0

Configuration

Overwrite Setting

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 247 248

Sem comentários

Allied-telesis AT-S97 Manual do Utilizador Página 37