Allied-telesis AT-S97 Manual do Utilizador descarregar pdf (Página 59)

AT-S85 and AT-S97 Management Software User’s Guide

SYSTEM SET CHASSIS

Syntax

system set chassis id=

chassis

name=

name

Parameters

id Identifies an ID number of a chassis you want to assign a

new name. The range is 0 to 31. To view an ID number of a

chassis, refer to “SYSTEM SHOW CLUSTER” on

page 101. For background information, refer to “Chassis ID

Numbers” on page 25.

name Specifies a new name for a chassis. A name can be up to

20 alphanumeric characters. Spaces are permitted, but

names with spaces must be enclosed in double quotes (“ “).

To remove the current value without specifying a new

value, enter “none”.

Privilege Levels

Administrator and read-write.

Description

This command is used to assign a name to a chassis. Identifying the

different AT-MCF2000 and AT-MCF2300 Chassis in the management

software will be easier if you give them names.

The difference between this command and the SYSTEM SET

HOSTNAME command is that this command is used to assign names to

the individual units in a stack while the latter command is used to assign

names to entire stacks.

To view the current name of a chassis, refer to “SYSTEM SHOW

CHASSIS” on page 99 or “SYSTEM SHOW CLUSTER” on page 101.

Examples

This command assigns the name “interconnect51” to the chassis with the

ID number 0:

system set chassis id=0 name=interconnect51

This command assigns the name “wtc connection” to the chassis with the

ID number 2:

system set chassis id=2 name="wtc connection"

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 247 248

Sem comentários

Allied-telesis AT-S97 Manual do Utilizador Página 59