Allied-telesis AT-S25 Manual do Utilizador descarregar pdf (Página 105)

AT-S25 Management Software User’s Guide

105

Configuring a

Port’s STP

Settings

To adjust a port’s STP parameters, perform the following procedure:

1. From the Spanning Tree Menu, type 2 to select Active Protocol Version.

The following prompt is displayed:

Enter new value (S-STP, R-RSTP):

2. Type S to select STP.

3. Type 3 to select STP Configuration.

The STP Menu in Figure 32 on page 103 is displayed.

4. From the STP Menu, type P to select STP Port Parameters.

The STP Port Parameters menu in Figure 33 is displayed.

Figure 33 STP Port Parameters Menu

5. From the STP Port Parameters window, type M if you wish to select a

module other than the one currently displayed.

The prompt message is displayed:

Select Module ID: [1 to 8] ->

6. Enter the ID of the module you wish to select, and press the Enter key.

7. From the RSTP Port Parameters window, type 1 to select Configure

RSTP Port Settings.

The following prompt is displayed:

Start Port to configure [1 - 24] ->

8. Enter the number of the port you wish to configure. To configure a

range of ports, enter the first port of the range. Press the Enter key.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 276 277

Sem comentários

Allied-telesis AT-S25 Manual do Utilizador Página 105