Allied-telesis AT-S25 Manual do Utilizador descarregar pdf (Página 229)

AT-S25 Management Software User’s Guide

229

Enabling or Disabling STP or RSTP

To enable or disable spanning tree protocol (STP) or rapid spanning tree

protocol (RSTP) on the bridge, perform the following procedure:

1. From the Home page, select Configuration.

2. From the Configuration page, select Layer 2 tab.

3. From the Layer 2 page, select the Spanning Tree tab.

The Spanning Tree window in Figure 86 is displayed.

Figure 86 Configuration - Spanning Tree Window

4. To enable or disable spanning tree, click the Enable Spanning Tree

check box. A check indicates that the feature is enabled while no

check indicates that the feature is disabled. The default is disabled.

5. If you are activating spanning tree, select either the STP or RSTP in the

Active Protocol Version section of the window. The default is RSTP.

Note

Only one spanning tree protocol can be active on the switch at a

time.

6. Click Apply.

7. If you activated STP, go to Configuring STP on page 233.

8. If you activated RSTP, go to Configuring RSTP on page 238.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 276 277

Sem comentários

Allied-telesis AT-S25 Manual do Utilizador Página 229