Allied-telesis AT-S25 Manual do Utilizador descarregar pdf (Página 185)

AT-S25 Management Software User’s Guide

185

❑ To download a file using TFTP, perform the following procedure:

a. Type T and press the Enter key. The following prompt is

displayed:

TFTP Server IP address:

b. Enter the IP address of the TFTP server. The following prompt

is displayed:

Remote File Name:

c. Enter the directory path and file name of the new

management software image that you wish to download;

then press the Enter key.

Note

The image file must be stored on the TFTP server.

Once the filename has been specified, the download begins.

Downloading an AT-S25 image file can take several minutes.

If you are installing a new management image file, the switch

begins to initialize the software after it is installed, a process that

takes approximately one minute to complete. Once the

management software is initialized, the switch will automatically

reboot with the new image file.

When downloading a new management image file using TFTP,

this image file is downloaded onto the Master switch of a stack

first. Then, from the Master switch, it gets downloaded onto all the

Slave switches in the stack. Once the downloading onto the Slave

switches is finished, the entire stack will reboot with the new

image file.

Note

Do not interrupt the initialization process. Do not reboot the switch.

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 276 277

Sem comentários

Allied-telesis AT-S25 Manual do Utilizador Página 185